1.anodized parts, if the part or the whole surface is not allowed to have clamping, the process should be left to do the loading card.The parts for anodizing can be mounted on general hanging tools or special hangers according to their appearance and Maintain a certain spacing between each fixture to avoid 6061 aluminum plates.
2. Aluminum rivet, gasket and other small parts can be installed in the rivet basket for anodic oxidation.Before filling the basket, the rivet should be corroded, out of light, cleaned and then filled with baskets.When oxidizing, in order to increase the conductive contact and reduce the amount of rework, in the case of the rivet filling, some aluminum ducts can be added, and mixed with rivet and gasket.Fill it with a gland and fasten it up and down with aluminum nuts.
3. When fixed, you can shake it to hear if there is a loose sound.If there is a loud noise, you should tighten it again, but don't tighten it too tightly.Before mounting, the hanger must be corroded or filed to remove the old oxide film on the surface.
4. When mounting, it is necessary to hold a fast card, but it cannot break the parts, especially the parts that are machined with thread.The large skin is mounted on a medium suspension, and the bolts are tightened to prevent falling off in the solution.The parts made of the same material should be mounted on a hanger and not allowed to have two parts made of two materials.
Five, the box parts, tube parts and a blind hole machining parts must make parts of hole, mouth up, and let the fumes, anodic oxidation can rule out freely, otherwise it will form the air bag, make local surface oxide film.
